Point of use of motorized sprayer

Update:29 Mar 2019
Summary:

Properly install the parts of the motorized sprayer acc […]

Properly install the parts of the motorized sprayer according to the instructions. After installation, first test with water to check for dripping and running.
When using, first add one-third of the water, then pour the medicine, then add water to reach the concentration of the liquid, but note that the liquid level of the liquid cannot exceed the safe water level. When the reagent is filled for the first time, since the spray bar contains clean water, it is officially started after two or three minutes of test spraying.
After the work is completed, the residual liquid in the barrel should be poured out in time, and then cleaned with water. If the motorized sprayer is not used in a short period of time, the fuel and lubricating oil should be cleaned, and the oil circuit should be cleaned in time. At the same time, the outside of the machine should be wiped dry and stored in a cool dry place. If it is not used for a long time, it should first lubricate the moving parts to prevent rust and seal them in time.
Most of the currently used motorized sprayers use mixed oils, which are mixed from 15:1 to 20:1. It is best to use two-stroke special oil for the oil. Must stop when refueling, pay attention to fire prevention.
After starting and before stopping, it must be run at low speed for 3 minutes to 5 minutes at no load. It is strictly forbidden to run at high speed and stop suddenly. The new machine can be used for 24 hours to load work.